1
QB64 Discussion / Re: Controlling test equipment with HP-IB using QB64
« on: October 30, 2018, 03:33:58 pm »
@doppler: I read your comment after I modified my first comment. Thanks
BASIC for the modern era.
News:
Listen to QB64 Report!
Our podcast on all things QB64 is out now. Listen at
http://podcast.qb64.org
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
QB64 Discussion / Re: Controlling test equipment with HP-IB using QB64
« on: October 29, 2018, 12:18:19 pm »
Thanks for info. However this does not exactly fit my needs.
Meanwhile I found some good examples for HP-IB communication using QB45. But all are using National Instruments GPIB adaptor with a file QBdecl.bas, none of them use the HP adaptor. So I have to find out if QBdecl.bas works wit the HP adaptor, if not I hope I will be able to modifiy.
It is quite a long time I have done programming, so I am on a learning curve agaain.
Meanwhile I found some good examples for HP-IB communication using QB45. But all are using National Instruments GPIB adaptor with a file QBdecl.bas, none of them use the HP adaptor. So I have to find out if QBdecl.bas works wit the HP adaptor, if not I hope I will be able to modifiy.
It is quite a long time I have done programming, so I am on a learning curve agaain.
3
QB64 Discussion / Controlling test equipment with HP-IB using QB64
« on: October 28, 2018, 03:50:03 pm »
Could anyone help me with this problem, please. I had done this in my job about 30 years ago using Quick Basic,
but unfortunately the code is lost and I have no idea how I did it.
Now I use a hp 82357B (HP-IB to USB) interface which works well with some other programs.
So it would help me much, if somebody has written some code that gives me startpoint.
Regards
Ernie49
but unfortunately the code is lost and I have no idea how I did it.
Now I use a hp 82357B (HP-IB to USB) interface which works well with some other programs.
So it would help me much, if somebody has written some code that gives me startpoint.
Regards
Ernie49
Pages: [1]