Where to put DATA lines?

[Qwerkey]

Fellippe, quick question: where's the best place to put DATA lines in the .bas?  In a non-InForm .bas this would be after SYSTEM (assuming this or similar exists), but there isn't such a thing for an InForm-created file.  Right at the end of all the SUB's?

[Qwerkey]

Supplementary question (which may have been asked elsewhere): May I use _KEYDOWN, or do I have to use the InForm equivalents?

[FellippeHeitor]

Fellippe, quick question: where's the best place to put DATA lines in the .bas?  In a non-InForm .bas this would be after SYSTEM (assuming this or similar exists), but there isn't such a thing for an InForm-created file.  Right at the end of all the SUB's?

If it’s just a data block, no labels, you can add them after the last sub in your main .bas. If you’ll need labels for RESTORE, add them before the external modules are $INCLUDEd.

Supplementary question (which may have been asked elsewhere): May I use _KEYDOWN, or do I have to use the InForm equivalents?

No problem using _KEYDOWN. For _KEYHIT, use __UI_KeyHit instead.

[FellippeHeitor]

If the data is only relevant to a specific sub or function, you can place it inside said procedure, labels allowed.

[Qwerkey]

Fellippe, further supplementary question, which I only ask out of nervousness (I should be more confident in my beliefs):  If a Frame is Disabled and Hidden are ALL the controls upon it also Disabled and Hidden?  In practice, I have found this to be so as it should be, so apologies for the mithering ("mither": northern English verb for to bother).  Thanks.

[FellippeHeitor]

Your assumption is correct 🙂

[TempodiBasic]

Hi Qwerkey
just a question...
but don't you like to read book?
:-) I assume no.