QB64.org Forum
Active Forums => QB64 Discussion => Topic started by: Richard on April 09, 2021, 09:25:53 pm
-
When resizing IDE - where the cursor points to is not exactly where the pivot point for the sizing action takes place.
Refer to attached screenshots (greatly magnified) - note that the green cursor cross-lines are 3 pixels thick and that windows screenshot does not show the actual cursor. The cursor was located so that both horizontal and vertical sizing is simultaneous.
[ This attachment cannot be displayed inline in 'Print Page' view ]
[ This attachment cannot be displayed inline in 'Print Page' view ]
[ This attachment cannot be displayed inline in 'Print Page' view ]
[ This attachment cannot be displayed inline in 'Print Page' view ]
[ This attachment cannot be displayed inline in 'Print Page' view ]